Hacking 3D Printer Infill Patterns
I 3D-printed these earrings using a cool little hack of setting top and bottom wall thickness to 0.
The pattern is the Tri-Hexagon infill that comes built-in with Ultimaker Cura. Other than the unusual wall thickness setting, the other settings are the defaults for the Standard Quality 0.2mm profile.

The infill hack is by Penolopy Bulnick. I followed her Instructable to learn how infill patterns work in 3D printing.
The pattern is the Tri-Hexagon infill that comes built-in with Ultimaker Cura. Other than the unusual wall thickness setting, the other settings are the defaults for the Standard Quality 0.2mm profile.

The infill hack is by Penolopy Bulnick. I followed her Instructable to learn how infill patterns work in 3D printing.
Comments
Post a Comment
Hey there, I just want to let you know that I read all comments. Thanks for taking the time to write something. Your words mean a lot to me. Be gentle and kind - this is a space where I post my works-in-progress, good or bad, and it can be hard putting my art out there.